Skip to main content
Passa alla visualizzazione normale.

ANTONIO PANTANO

Inspection of additive-manufactured layered components

  • Authors: Cerniglia, D.; Scafidi, M.; Pantano, A.; Rudlin, J.
  • Publication year: 2015
  • Type: Articolo in rivista (Articolo in rivista)
  • OA Link: http://hdl.handle.net/10447/137212

Abstract

Laser powder deposition (LPD) is a rapid additive manufacturing process to produce, layer upon layer, 3D geometries or to repair high-value components. Currently there is no nondestructive technique that can guarantee absence of flaws in LPD products during manufacturing. In this paper a laser ultrasonic technique for in-line inspection of LPD components is proposed. Reference samples were manufactured from Inconel and machined flaws were created to establish the sensitivity of the technique. Numerical models of laser-generated ultrasonic waves have been created to gain a deeper understanding of physics, to optimize the set-up and to verify the experimental measurements. Results obtained on two sets of reference samples are shown. A proof-of-concept prototype has been demonstrated on some specific deposition samples with induced flaws, that were confirmed by an ultra-high sensitivity X-ray technique. Experimental outcomes prove that typical micro-defects due to the layer-by-layer deposition process, such as near-surface and surface flaws in a single layer deposit, can be detected.