Salta al contenuto principale
Passa alla visualizzazione normale.

PIETRO ALESSANDRO DI MAIO

On the thermal and thermomechanical assessment of the “Optimized Conservative” helium-cooled lithium lead breeding blanket concept for DEMO

  • Autori: Bongiovì, G.*; Aiello, G.; Aubert, J.; Di Maio, P.A.
  • Anno di pubblicazione: 2018
  • Tipologia: Articolo in rivista (Articolo in rivista)
  • OA Link: http://hdl.handle.net/10447/328941

Abstract

Within the framework of EUROfusion R&D activities a research campaign has been performed at CEA-Saclay, in close collaboration with the University of Palermo, in order to investigate thermal and thermomechanical performances of the “Optimized Conservative” concept of DEMO Helium-Cooled Lithium Lead breeding blanket (HCLL). Attention has been paid to the HCLL outboard equatorial module (OEM) when subjected to the steady state nominal loading scenario. To this purpose three simplified 3D models, characterized by an increasing level of detail, have been set-up taking into account, firstly, a single radial-toroidal slice, then a basic module geometric unity composed by two adjacent slices and adding, lastly, the peripheral poloidal region. This latter 3D model has allowed the assessment of the Caps potential influence on the module thermal and thermomechanical behaviour. For each investigated 3D model, thermal and thermomechanical analyses have been performed and a stress linearization procedure has been carried out in order to verify the fulfilment of the criteria prescribed by the RCC-MRx 2015 code. The study has been performed adopting a numerical approach, based on the Finite Element Method (FEM), and adopting the Siemens NX v. 10.0 software in order to discretize the geometric domain, whereas thermal and thermomechanical calculations have been carried out using the Cast3 M 2015 FEM code. The obtained results, herewith reported and critically discussed, allow predicting a good thermal and mechanical behaviour of the “Optimized Conservative” concept of DEMO HCLL OEM, even if some small modifications to the module cooling scheme should be performed in order to avoid the insurgence of hotspots where temperature is slightly above the Eurofer limit temperature (550 °C). This will entail, from the mechanical point of view, a reduction of the secondary stress amount which is the main responsible of the failure in RCC-MRx criteria verification within First Wall-Side Wall bend region.